Home   A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Early IANA Allocation of Standards Track Code Points :: RFC4020








Network Working Group                                        K. Kompella
Request for Comments: 4020                              Juniper Networks
BCP: 100                                                        A. Zinin
Category: Best Current Practice                                  Alcatel
                                                           February 2005


          Early IANA Allocation of Standards Track Code Points

Status of This Memo

   This document specifies an Internet Best Current Practices for the
   Internet Community, and requests discussion and suggestions for
   improvements.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2005).

Abstract

   This memo discusses earlier allocation of code points by IANA as a
   remedy to the problem created by the "Standards Action" IANA policy
   for protocols for which, by the IETF process, implementation and
   deployment experience is desired or required prior to publication.

1.  Introduction

   In Standards Track RFCs, there is often a need to allocate code
   points for various objects, messages, or other protocol entities so
   that implementations can interoperate.  Many of these code point
   spaces have registries handled by the Internet Assigned Number
   Authority (IANA).  Several IANA allocation policies are described in
   RFC 2434 [2434].  Some of them, such as First Come First Served or
   Expert Review, do not require a formal IETF action before the IANA
   performs allocation.  However, in situations where code points are a
   scarce resource and/or the IETF community is willing to retain tight
   control of the protocol, policies such as IESG Approval, IETF
   Consensus, or Standards Action have been used.  The Standards Action
   policy represents a problem in situations where implementation and/or
   deployment experience are desired or required for the Standards
   Action.

   To break the deadlock, "pre-RFC" implementations have sometimes
   simply chosen some "seemingly unused" code points; these may turn out
   to be different from those later assigned by IANA.  To make matters
   worse, these "pre-RFC" implementations are often deployed.  This
   creates several potential interoperability problems between early



Kompella & Zinin         Best Current Practice                  [Page 1]

RFC 4020        Early Allocation of Standard Code Points   February 2005


   implementations and implementations of the final standard, as
   described below:

   1. IANA allocates code points different from those that early
      implementations assumed would be allocated.  Early implementations
      won't interoperate with standard ones.

   2. IANA allocates code points used silently for other extensions.
      Different extensions will collide.

   This gets in the way of the main purpose of standards; namely, to
   facilitate interoperable implementations.

   It is easy to say that pre-RFC implementations should be kept private
   and should not be deployed; however, both the length of the standards
   process and the immense value of early implementations and early
   deployments suggest finding a better solution.  As an example, in the
   case of documents produced by Working Groups in the Routing Area, a
   pre-RFC implementation is highly desirable and sometimes even
   required, and early deployments provide useful feedback on the
   technical and operational quality of the specification.

   This memo proposes that, under strictly controlled circumstances,
   IANA make an early allocation of code points.  The memo lays out the
   conditions for early allocation, as well as the process to be
   followed; it also says how these allocations are dealt with in the
   event of a failure in the process (such as the RFC not being
   published).

   This memo only addresses the early allocation of code points from
   spaces whose allocation policy is "Standards Action" [2434] AND that
   have been amended to permit early allocation.  This permission must
   be granted by the IESG, and code spaces with permission for early
   allocation must be marked as such in the IANA registry.

2.  Conditions for Early Allocation

   The following conditions must hold before a request may be made for
   early allocation of code points:

   a) The code points must be from a space designated as "Standards
      Action", amended by IESG approval to permit Early Allocation.

   b) The format, semantics, processing, and other rules related to
      handling the protocol entities defined by the code points
      (henceforth called "specifications") must be adequately described
      in an Internet draft that is proposed as Standards Track.




Kompella & Zinin         Best Current Practice                  [Page 2]

RFC 4020        Early Allocation of Standard Code Points   February 2005


   c) The specifications of these code points must be stable; i.e., if
      there is a change, implementations based on the earlier and later
      specifications must be seamlessly interoperable.

   d) There is sufficient interest in early (pre-RFC) implementation and
      deployment in the community.

   If conditions (a) or (b) are not met, then the processes in this memo
   do not apply.

3.  Process for Early Allocation

   There are three processes associated with early allocation: making
   the request for code points; following up on the request; and
   revoking an early allocation.  It cannot be emphasized enough that
   these processes must have a minimal impact on IANA itself, or they
   will not be feasible.

   The processes described below assume that the document in question is
   the product of an IETF Working Group.  If this is not the case,
   replace "WG chairs" below with "shepherding Area Director".

3.1.  Request

   The process for requesting and obtaining early allocation of code
   points is as follows:

   1) The authors (editors) of the document submit a request for early
      allocation to the Working Group chairs, specifying which code
      points require early allocation and which document they should be
      assigned to.

   2) The WG chairs determine whether the conditions for early
      allocations described in section 2 are met; particularly,
      conditions (c) and (d).

   3) The WG chairs gauge whether there is consensus within the WG that
      early allocation is appropriate in the case of the given document.

   4) If it is, with the approval of the Area Director(s), the WG chairs
      request IANA to make an early allocation.

   5) IANA makes an allocation from the appropriate registry, marking it
      as "temporary", valid for a period of one year from the date of
      allocation.  The date of allocation should also be recorded in the
      registry and made visible to the public.





Kompella & Zinin         Best Current Practice                  [Page 3]

RFC 4020        Early Allocation of Standard Code Points   February 2005


   Note that Internet Drafts should not include a specific value of a
   code point until this value has been formally allocated by IANA.

3.2.  Follow-Up

   It is the responsibility of the document authors and the Working
   Group chairs to review changes in the document, and especially in the
   specifications of the code points for which early allocation was
   requested, to ensure that the changes are backward compatible.

   If at some point changes that are not backward compatible are
   nonetheless required, a decision needs to be made as to whether
   previously allocated code points must be deprecated (see section 3.3
   for more information on code point deprecation).  The considerations
   include aspects such as the possibility of existing deployments of
   the older implementations and, hence, the possibility for a collision
   between older and newer implementations in the field.

   If the document progresses to the point at which IANA normally makes
   code point allocations, it is the responsibility of the authors and
   the WG chairs to remind IANA that there were early allocations, and
   of the code point values so allocated, in the IANA Considerations
   section of the RFC-to-be.  Allocation is then just a matter of
   removing the "temporary" tag from the allocation description.

3.3.  Expiry

   If early allocations expire before the document progresses to the
   point where IANA normally makes allocations, the authors and WG
   chairs may follow an abbreviated version of the process in section
   3.1 to request renewal of the code points.  At most, one renewal
   request may be made; thus, authors should choose carefully when the
   original request is to be made.

   As an exception to the above rule, under rare circumstances, more
   than one allocation renewal may be justified.  All such renewal
   requests must be reviewed by the IESG.  The renewal request to the
   IESG must include the reasons why such renewal is necessary, and the
   WG's plans regarding the specification.

   If a follow-up request is not made, or the document fails to progress
   to a Standards Track RFC, the WG chairs are responsible for informing
   IANA that the code points are to be marked "deprecated" (and are not
   to be allocated).  The WG chairs are further responsible for
   informing IANA when the deprecated code points can be completely de-
   allocated (i.e., made available for new allocations).





Kompella & Zinin         Best Current Practice                  [Page 4]

RFC 4020        Early Allocation of Standard Code Points   February 2005


   In particular, it is not IANA's responsibility to track the status of
   allocations, their expiration, or when they may be re-allocated.

   Note that if a document is submitted for review to the IESG and at
   the time of submission some early allocations are valid (not
   expired), these allocations should not be expired while the document
   is under IESG consideration or waiting in the RFC Editor's queue
   after approval by the IESG.

4.  IANA Considerations

   This document defines procedures for early allocation of code points
   in the registries with the Standards Action policy and as such
   directly affects IANA functions.

5.  Normative References

   [2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an IANA
          Considerations Section in RFCs", BCP 26, RFC 2434, October
          1998.

6.  Security Considerations

   It is important to keep in mind 'denial of service' attacks on IANA
   as a result of the processes in this memo.  There are two that are
   immediately obvious: depletion of code space by early allocations and
   process overloading of IANA itself.  The processes described here
   attempt to alleviate both of these, but they should be subject to
   scrutiny to ensure this.

7.  Acknowledgements

   Many thanks to Bert Wijnen, Adrian Farrel, and Bill Fenner for their
   input.

















Kompella & Zinin         Best Current Practice                  [Page 5]

RFC 4020        Early Allocation of Standard Code Points   February 2005


Authors' Addresses

   Kireeti Kompella
   Juniper Networks
   1194 N. Mathilda Ave
   Sunnyvale, CA 94089 USA

   EMail:  kireeti@juniper.net


   Alex Zinin
   Alcatel
   701 E Middlefield Rd
   Mountain View, CA 94043

   EMail: zinin@psg.com



































Kompella & Zinin         Best Current Practice                  [Page 6]

RFC 4020        Early Allocation of Standard Code Points   February 2005


Full Copyright Statement

   Copyright (C) The Internet Society (2005).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the IETF's procedures with respect to rights in IETF Documents can
   be found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.


Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.






Kompella & Zinin         Best Current Practice                  [Page 7]


 

RFC, FYI, BCP